cold install
When installing a small bearing that is not too tight, you can use a sleeve and hammer the sleeve to lightly tap the sleeve to install the bearing in a proper position. When knocking, it should act on the bearing ring as evenly as possible to prevent the bearing from tilting or skewing.
Most bearings are installed by pressing in. If the inner and outer rings of the bearing are to be installed on the shaft and the bearing housing at the same time, it must be ensured that the same pressure acts on the inner and outer rings at the same time, and must be on the same plane as the contact surface of the installation tool.
hot install
Typically, the installation of larger bearings is not possible without heating the bearing or housing, since as size increases, more force is required to install. The temperature difference between the bearing ring and the shaft or housing required for hot mounting depends primarily on the interference and the diameter of the bearing fit. The heating temperature of the open bearing shall not exceed 120. It is not recommended to heat bearings with seals and dust caps above 80C (make sure that the temperature does not exceed the temperature allowed by the seals and grease). When heating the bearing, it should be heated evenly, and there must be no local overheating.
BRIEF INTRODUCTION
Cnbearing is the No.1 bearing inquiry system and information service in China, dedicated to helping all bearing users and sellers throughout the world.
Cnbearing is supported by China National Bearing Industry Association, whose operation online is charged by China Bearing Unisun Tech. Co., Ltd.
China Bearing Unisun Tech. Co., Ltd owns all the rights. Since 2000, over 3,000 companies have been registered and enjoyed the company' s complete skillful service, which ranking many aspects in bearing industry at home and abroad with the most authority practical devices in China.